Fully Open CCS Charge Controller (FOCCCI)

From openinverter.org wiki
Jump to navigation Jump to search

Disclaimer: This Page is still work in progress! Any information written here is a draft only and should be handled as such. Contributions more then welcome. If you have questions please ask them in the discussion section of the page or in the OpenInvert Forum.

Foccci (v3) pinout


This page is about FOCCCI. FOCCCI is an open source CCS Charge Controller started by Uhi and developed by the OpenInverter Community.

Here you will find documentation on the Hardware, where to get it (or how to build it yourself), News regarding the development and many more great things.


Focci runs on the reference software CCS32Clara (also referred to as Clara).


Focci on Github.

Focci in the OpenInverter Forum.

Pin description

External connector ("Deutsch Header")

Pin nr Short name Description
A1
A2
A3
A4
A5
A6
A7
A8
A9
A10
A11
A12
B1
B2
B3
B4
B5
B6
B7
B8
B9
B10
B11
B12

Internal connectors

short name description
UART TX
UART RX
SWCLK
SWDIO

Hardware detection

3.3v Addressing Voltage Divider.png

To allow software to reliably detect which version hardware it runs on, in HW version 4.1 a version indication resistor was added. As opposed to some other boards that run at 5.3V, the voltage here is 3.3V.

Variant R1 R2 voltage ADC -3% +3%
- 47 2,7 0,179 222 216 229
- 47 3,3 0,217 269 261 277
- 47 3,9 0,253 314 304 323
- 47 4,7 0,300 372 361 383
- 47 5,1 0,323 401 389 413
- 47 5,6 0,351 436 423 449
- 47 6,8 0,417 518 502 533
- 47 7,5 0,454 564 547 580
4.0 with economizer 47 8,2 0,490 608 590 627
- 47 9,1 0,535 664 644 684
4.2 47 10 0,579 718 697 740
4.3 47 12 0,671 833 808 858
4.4 47 15 0,798 991 961 1020
4.5 47 18 0,914 1134 1100 1168
47 22 1,052 1306 1266 1345
47 27 1,204 1494 1449 1539
47 33 1,361 1689 1639 1740
47 39 1,497 1857 1801 1913
47 47 1,650 2048 1986 2109
47 56 1,794 2226 2160 2293