Flying ADC 16 channel BMS 96S test

[PetersonOctavius]

The 2.4 Version works no problems so far. still do not know how to make them balance. never seen them saying "balancing"

check all the down in the spot values tab. you ll see if the cells are being discharged of charged

[Proton]

Quick update:

the boards have 12v all the time. When I turn the car on sometimes board 5 and 6 do not power on, sometimes just board 6 does not power on. I have to turn off the 12 v to all boards, then turn it back on and then turn on the car.

[johu]

Quick update:

the boards have 12v all the time. When I turn the car on sometimes board 5 and 6 do not power on, sometimes just board 6 does not power on. I have to turn off the 12 v to all boards, then turn it back on and then turn on the car.

Ok, will test that but that if for after my holiday

[Volkmar]

Hi,

I´m building an electric car with Volvo Battery Packs 96S. I use a Telsa SDU with the OI Board, a ZombieVCU ISA Shunt and the Foccci. For the BMS I use the board, which Catfish developed.
viewtopic.php?t=2123

Now my problem: the BMS does not submit MaxChargingCurrent and no SoC to the CAN bus and I can not perform successful charging. I think this Information is essential and crucial for a successful charging via the Foccci.

Since I have no idea about programming at all, I think the best option is to switch to the Flying ADC BMS.

Does anyone knows if or when the Flying ADC BMS will be integrated to the ZombieVCU? (in the moment Relelase V2.22A does not yet support)

Thank you for your support!

Best regards

Volkmar

[Jacobsmess]

You could (as advised to me by Tom91), use the simpBMS class on zombie and map the required information from the Flying ADC BMS to those IDs.