SimpBMS V2.3/2.4 Printed Housing

[tom91]

A couple of people have asked about a 3d printed housing or a housing in general for the SimpBMS.

I have drawn one up, it comes in two pieces a bottom and a cover. It is deigned to work with drg-01 din mounts if so desired.

The top half just fits snug on the bottom so no true "fixings" are used. The SimpBMS is held into the base with 4 No.2 selftapping screws.

s-l300.jpg (8.47 KiB) Viewed 1594 times

[raine]

Thanks Tom. Good work.

[alexbeatle]

Great work, Tom. Thank you.