Software 4.59 v1

Peter · Post by **Peter** » Mon May 27, 2019 11:35 am

Hi Johannes. As you are aware a few of us are using v1 of the software after removing R21 on Damiens controller board. My question being does the CAN part of the software work in v1? Thought I would ask the guru himself before I start working on the CAN interface. Thanks once again. Peter

YouTube · Post by **johu** » Mon May 27, 2019 1:49 pm

Yes I only disable parts of the software for a given revision if there are resource conflicts. There is no resource conflict around CAN, so it is always enabled

Peter · Post by **Peter** » Mon May 27, 2019 2:15 pm

Thanks you Johannes. Glad it is enabled, my next task is to be able to read and implement the CAN on my Arduino. Keep up the good work. Peter

Software 4.59 v1

Software 4.59 v1

Re: Software 4.59 v1

Re: Software 4.59 v1