Canbus

Post Reply
zippy500
Posts: 247
Joined: Fri Jan 04, 2019 8:42 am
Location: United Kingdom
Has thanked: 100 times
Been thanked: 7 times

Canbus

Post by zippy500 »

Is there how too /setup , If Can input signals are used (throttle etc) how are these signal inputs configured to the V3 board ?

I don't have much knowledge on Canbus signals
Top
User avatar
Kevin Sharpe
Posts: 1339
Joined: Fri Dec 14, 2018 9:24 pm
Location: Ireland and US
Been thanked: 10 times

Re: Canbus

Post by Kevin Sharpe »

zippy500 wrote: ↑Mon Apr 20, 2020 5:27 pm Is there how too /setup , If Can input signals are used (throttle etc) how are these signal inputs configured to the V3 board ?
Always start a knowledge quest with the wiki :)

https://openinverter.org/wiki/CAN_communication
This is a personal post and I disclaim all responsibility for any loss or damage which any person may suffer from reliance on the information and material in this post or any opinion, conclusion or recommendation in the information and material.
Top
zippy500
Posts: 247
Joined: Fri Jan 04, 2019 8:42 am
Location: United Kingdom
Has thanked: 100 times
Been thanked: 7 times

Re: Canbus

Post by zippy500 »

ok Thanks, will take a look
Top
Post Reply

Return to “Drive trains (motors and inverters)”