Hello. Please tell me, does anyone have a PCB diagram in gerber format for ZombieVerter?
Is it only possible to buy it or can I make it myself as well? Thx
PCB board scheme
-
johu
- Site Admin
- Posts: 6708
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 367 times
- Been thanked: 1536 times
- Contact:
Re: PCB board scheme
To my knowledge the gerber files are not public
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
-
tom91
- Posts: 2391
- Joined: Fri Mar 01, 2019 9:15 pm
- Location: Bristol
- Has thanked: 206 times
- Been thanked: 563 times
Re: PCB board scheme
Thx to answer. I saw the schematic on github. If this schematic is correct then I will convert it to pcb. Do you think this schematic is correct?
https://github.com/damienmaguire/Stm32- ... ematic.pdf ?
https://github.com/damienmaguire/Stm32- ... ematic.pdf ?
-
johu
- Site Admin
- Posts: 6708
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 367 times
- Been thanked: 1536 times
- Contact:
Re: PCB board scheme
You can't "convert" a schematic to PCB, you'd have to re-route the whole thing.
As far as I know the schematic has been published for reasons of repair-ability not to help people rip off the design.
Just buy the board if you want to use it. Damien & friends rely on an income in order to keep developing it.
As far as I know the schematic has been published for reasons of repair-ability not to help people rip off the design.
Just buy the board if you want to use it. Damien & friends rely on an income in order to keep developing it.
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9