Hi and please help
I'm trying to set up the GS450H to test it. I have updated to version 2.15.A and I do get the Zombie in to Run mode but I don't get any power on pin 32 (Inverter Power LS switch).
I understand that pin is to connect to a relay for power Inverter and the relay for the oil pump.
Any special settings for this?
Grateful for any help.
Zombie gives no power to Inverter pin Topic is solved
-
tom91
- Posts: 1333
- Joined: Fri Mar 01, 2019 9:15 pm
- Location: Bristol
- Has thanked: 106 times
- Been thanked: 228 times
Re: Zombie gives no power to Inverter pin
It is a LS (low side) or a pull to ground pin.
So you need to wire it as such, 12V to the relay other side to the pin.
So you need to wire it as such, 12V to the relay other side to the pin.
Re: Zombie gives no power to Inverter pin
Thank you. That made a big difference
It works now. Just need to get an accelerator pedal to run it now