dout_prec and dout_dcsw always seem to show 0

Post Reply
User avatar
joromy
Posts: 371
Joined: Fri Jun 28, 2019 12:56 pm
Has thanked: 1 time
Been thanked: 4 times

dout_prec and dout_dcsw always seem to show 0

Post by joromy »

dout_prec and dout_dcsw always seem to show 0

viewtopic.php?f=16&t=186&start=20#p6599

Got some question in the ranger forum. And have tried to find the answer for it, but no luck....
Tested today with my "test bench" truck, and got the same, the contactors are closed but show 0??
Is this normal?

Have tripmode set to 1=Keep DC switch closed. And have powersupply at 320V 20A, to be safe.


The connection is like this:
contactors.JPG
Thomas A. Edison “I have not failed. I've just found 10,000 ways that won't work"
Top
User avatar
johu
Site Admin
Posts: 7182
Joined: Thu Nov 08, 2018 10:52 pm
Location: Kassel/Germany
Has thanked: 552 times
Been thanked: 1913 times
Contact:
Contact johu

Re: dout_prec and dout_dcsw always seem to show 0

Post by johu »

Uhm yeah I forgot to "wire" these up. Might as well remove them.
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
Top
Post Reply

Return to “Drive trains (motors and inverters)”