@Damien can you comment on this?EV_Builder wrote: ↑Sun Nov 21, 2021 10:16 pm Are you sure? the MCP2003 has the wake-up? The MCP2004 has the fault pin there...
Is there a difference between V1 and V2 boards?
Are both versions available on Patreon?
@Damien can you comment on this?EV_Builder wrote: ↑Sun Nov 21, 2021 10:16 pm Are you sure? the MCP2003 has the wake-up? The MCP2004 has the fault pin there...
Kelju wrote: ↑Thu Dec 02, 2021 11:40 amThat should work just fine.PaulHeystee wrote: ↑Thu Dec 02, 2021 8:48 am Throtle pedal question: I bought a VW Polo diesel throtle pedal, I opended it and found that it looks like it is just two potentiometers.
Will this work?
You need to figure out which ones of the pins are the center taps of the potentiometer.
Then just wire 5V and GND to the other two pins of each potentiometer.
If you get 5V and GND mixed together, there should be no damage, but you need to get the direction right (that being an increasing voltage in function of percentage of throttle travel).
Keep in mind, that if you mix the center tap with either the 5V or GND, you risk damaging the 5V reference supply of the Zombie or damaging the throttle pedal (Assuming there is no short circuit protection).
Looking at the data sheets, it seems the opposite sense is needed for a couple of signals to give the same function. I think Damien said the driver isn't implemented for LIN yet anyway so it looks like it could be written for the available chip (MCP2004 is what's being supplied) and the early boards updated if LIN is needed (or with a #define).EV_Builder wrote: ↑Thu Dec 02, 2021 12:34 pm@Damien can you comment on this?EV_Builder wrote: ↑Sun Nov 21, 2021 10:16 pm Are you sure? the MCP2003 has the wake-up? The MCP2004 has the fault pin there...
Is there a difference between V1 and V2 boards?
Are both versions available on Patreon?
I am pretty sure altering the existing can IDs did not work before, but for some reason it does seem to work now.
Just wanted to share my findings on this pedal.PaulHeystee wrote: ↑Thu Dec 02, 2021 8:48 am Throtle pedal question: I bought a VW Polo diesel throtle pedal, I opended it and found that it looks like it is just two potentiometers.
Can I still use this?
What signals does the Zombieveter want to see, just 0 to 5 volts?
Will this work?
EV_Builder wrote: ↑Wed Dec 15, 2021 11:34 pm So basically you say that DHCP doesn't work on the wifi module...?
Well i thought about helping us out but it seems you don't see my questions or at least don't bother to answer them?Jack Bauer wrote: ↑Thu Dec 16, 2021 6:11 pm I'm up to my ears right now folks so sure would be a great time for some community support.
Jack Bauer wrote: ↑Thu Dec 16, 2021 6:11 pm Yes I posted about this here and requested help :
viewtopic.php?f=5&t=2001
I'm up to my ears right now folks so sure would be a great time for some community support.