As I understood UN2003A must be added.

Yes, I 'm using the square board Rev3.

How can I define that the inverter is working itself or not ? I see 0V on 7 and 12 its terminals instead of 2.5V .

Il_1 and Il_2 have 2.23 V potential.

Additionally, I got [15]: STOP - OVERCURRENT .

I have Board Rev.3 and Prius Gen2. Supply 12 V on all devices, but an oscilloscope does not show frequency on PWM1_any outputs in Manual Mode. Writes 'Invertor started', with no errors. Boost is 37813, ampnom 70 %. IN_MPROT, IN_START, IN_FWD are connected to 12 V. The red LED on the plate is blinking.

I have bought board Rev.3 recently . The network name is 'invertor'. But I did not find access point parole with it. Can you help me ?

if I connect a three-phase diode bridge and a capacitor to the output of the inverter, can I get a regulated DC voltage at the bridge output ?