SimpBMS V2.3/2.4 Printed Housing
Posted: Fri Apr 01, 2022 6:48 pm
A couple of people have asked about a 3d printed housing or a housing in general for the SimpBMS.
I have drawn one up, it comes in two pieces a bottom and a cover. It is deigned to work with drg-01 din mounts if so desired.
The top half just fits snug on the bottom so no true "fixings" are used. The SimpBMS is held into the base with 4 No.2 selftapping screws.
I have drawn one up, it comes in two pieces a bottom and a cover. It is deigned to work with drg-01 din mounts if so desired.
The top half just fits snug on the bottom so no true "fixings" are used. The SimpBMS is held into the base with 4 No.2 selftapping screws.