Sensor Board R3 Issues
Posted: Tue Aug 17, 2021 3:45 pm
Greetings from Taiwan!
I have built the Sensor board R3 according to the wiki schematic. However I am not getting appropriate UDC outputs from the voltage sensing circuit. The main board cannot see any UDC. The ATTiny13 was bought from Digikey (off the shelf component), does it require to be programmed for it to work? Where to find this program for the ATTiny13 to suit?
I am very close to getting my motor to spin via FOC!
Thanks very much!
I have built the Sensor board R3 according to the wiki schematic. However I am not getting appropriate UDC outputs from the voltage sensing circuit. The main board cannot see any UDC. The ATTiny13 was bought from Digikey (off the shelf component), does it require to be programmed for it to work? Where to find this program for the ATTiny13 to suit?
I am very close to getting my motor to spin via FOC!
Thanks very much!