Switching pins would still mean that motor runs reverse internally and hill hold etc won’t work
Tesla SDU forward direction
-
mane2
- Posts: 186
- Joined: Fri Jan 13, 2023 6:32 am
- Location: Finland
- Has thanked: 23 times
- Been thanked: 21 times
Re: Tesla SDU forward direction
Thanks for confirming.
Switching pins would still mean that motor runs reverse internally and hill hold etc won’t work
Switching pins would still mean that motor runs reverse internally and hill hold etc won’t work
-
johu
- Site Admin
- Posts: 5848
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 165 times
- Been thanked: 1071 times
- Contact:
Re: Tesla SDU forward direction
Yeah hill hold still needs debugging in that case, same problem in Audi.
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
-
alexbeatle
- Posts: 178
- Joined: Sun Jan 03, 2021 6:12 am
- Has thanked: 54 times
- Been thanked: 17 times
Re: Tesla SDU forward direction
Another small note. Setting the dirmode to "SwitchReversed" also inverts the seldir.
Example: if din_forward = on, seldir shows Reversed. The motor spins forward correctly.
I was trying to use the seldir as the signal for the dashboard display, but need to invert it, I guess. rotordit only updates after actually spinning the motor, so cannot use that.
Example: if din_forward = on, seldir shows Reversed. The motor spins forward correctly.
I was trying to use the seldir as the signal for the dashboard display, but need to invert it, I guess. rotordit only updates after actually spinning the motor, so cannot use that.