2008 Nissan Quest Van with Tesla SDU.

[PetersonOctavius]

nice, you just changed 9600 to 115200? no changes to the nextion display?

[Proton]

I changed both. Nextion display too.

[Proton]

So.... After I thought that my tesla charger works, now it shows fault on the 2 out of 3 inverers that I thought were running. They were only pushing about 1.8 amps and after about 2 hours I got "fault" error on the 2 working inverters.
I am looking now for a 3.3.or 6.6kw Chinese charger on Aliexpress.

This weekend if I have time I will try my 9mm tool and if that does not work I will move to the 308 tool. it is frustrating when you spent 700-800$ on this setup.
The boys are trained on all tools, but my daughter needs to start training on the 9mm.

[PetersonOctavius]

hahahahah those are some drastic measures

[Proton]

Octavius convinced me to check again before I used my metric tool and found out that this AC switch went out.

Now it is charging with 4 amps I tried to go higher but the inverter contractors keep going on and off. for now is good because is a thin AC cable and it is only 120V.

at least I am finally charging the battery.

[PetersonOctavius]

on 120v ac if you pull more than 10amps AC, the voltage drops so low that the charger resets itself, and tries again.

[johu]

Always use the correct tools when working with HV