My first post here so a quick intro

[2013coss]

Hello Forum.
My first post here so a quick intro....
I am using the Enova 3ph 90Kw motor coupled to the Enova power stage with the Damien/Johannes Combi V8 board and Johannes Olimex board running v4.87 software.
Not sure what to set the parameters to ?
I wish to use the full rpm range, max 9000rpm, motor rated voltage 208v.
DC bus voltage at present is 230v most probably will be increased to 280v later once I am rolling.
If anyone is based in the North West UK please say 'hello' too Maybe a chance to meet and greet fellow DIY enthusiasts.
All the best.

[Peter]

Hello 2013coss.
I see from your message you based in the North West. If so which town please? I am in Blackburn. All the best. Peter

[johu]

User 2013coss account was apparently taken over by a scammer. I've disabled the account.
If you get PMs with spam just delete

Hello Forum.