I am wiring up the 23 pin ampseal connector, and I noticed a discrepancy regarding the reverse gear on the wiki on this page here:
https://openinverter.org/wiki/Tesla_Mod ... _I/O_Plug
The table suggests reverse should be pin 8, but this image earlier on the page suggests it should be pin 5:
https://openinverter.org/wiki/File:LDU_ ... iagram.png
My assumption is that the correct pin for reverse (when using the open inverter LDU board) is pin 8.
Could anyone confirm?
Thanks,
- James
Possible error on OpenInverter Wiki ? [SOLVED]
-
- Posts: 19
- Joined: Sun Jul 23, 2023 12:28 am
- Has thanked: 2 times
- Been thanked: 1 time
- johu
- Site Admin
- Posts: 5831
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 162 times
- Been thanked: 1045 times
- Contact:
Re: Possible error on OpenInverter Wiki ? [SOLVED]
Actually on the same page in the "non-zoomed" diagram it also says pin 8 so assuming that is correct
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
-
- Posts: 19
- Joined: Sun Jul 23, 2023 12:28 am
- Has thanked: 2 times
- Been thanked: 1 time
Re: Possible error on OpenInverter Wiki ?
I installed the open inverter board today into the LDU and booted it up via the harness. I can confirm that pin 8 is the correct pin for reverse (I flipped the switch to reverse and the value was reflected correctly in open inverter).