Guys,
I'm panning using a custom digital dash board to display info such as speed, temperature and all that kind of things....can I get all that data from the OI inverter board or do I need a shunt resistor?
Shunt needed with OI board?
-
- Posts: 43
- Joined: Mon Sep 20, 2021 8:09 pm
- Has thanked: 4 times
- Been thanked: 5 times
-
- Posts: 3265
- Joined: Mon Dec 24, 2018 1:37 pm
- Location: Slovenia
- Has thanked: 80 times
- Been thanked: 234 times
- Contact:
Re: Shunt needed with OI board?
Hm... OI can output CAN data stream. But i dont know if you can directly use the DC current data. Maybe not really accurate...ardillolambo wrote: ↑Wed Dec 07, 2022 2:14 pm Guys,
I'm panning using a custom digital dash board to display info such as speed, temperature and all that kind of things....can I get all that data from the OI inverter board or do I need a shunt resistor?
Speed and temp info is there and can be slaved to CAN.
- johu
- Site Admin
- Posts: 5791
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 157 times
- Been thanked: 1025 times
- Contact:
Re: Shunt needed with OI board?
The DC current figure is as accurate as the current sensors are calibrated, That said it doesn't include miscellaneous currents like DC/DC, heater etc. Better source current from the BMS (or a shunt)
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
-
- Posts: 43
- Joined: Mon Sep 20, 2021 8:09 pm
- Has thanked: 4 times
- Been thanked: 5 times
Re: Shunt needed with OI board?
Johu
Any particular shunt that you will recommend for a dual motor set up?