Tesla Large Drive Unit Support Thread
- johu
- Site Admin
- Posts: 5831
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 162 times
- Been thanked: 1045 times
- Contact:
Re: Tesla Large Drive Unit Support Thread
oh, I understand. Is the mosfet IC5 shorted? Measure from the right pin (GND) to tab (positive).
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
-
- Posts: 30
- Joined: Tue Aug 09, 2022 12:54 pm
Re: Tesla Large Drive Unit Support Thread
In short, pin 3 and pin 6 are being activated since I started without activating the 12V of pin 23johu wrote: ↑Mon Nov 14, 2022 8:54 am I don't quite understand your issue yet, so will just give you general info
- Pin 3 becomes active as soon as you power up the drive unit - if less than udcsw/2 V are measured after 5s it will drop
- Pin 6 becomes active as soon as you give the start signal (12V, pin 23) AND udc>udcsw
- johu
- Site Admin
- Posts: 5831
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 162 times
- Been thanked: 1045 times
- Contact:
Re: Tesla Large Drive Unit Support Thread
I'm closing this support thread as it has become too long to be useful. Please describe new issues in a new thread with a descriptive title (I NEED HELP is not descriptive!). Do not put unrelated issues into existing threads that describe a different topic.
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9