Yes, if you bought the complete kit with software from Damien the PIN should be there but if you need a pin you buy it from Johu at openinverter.org...P.S.Mangelsdorf wrote: ↑Sat Dec 11, 2021 9:07 pmYes I have the correct wiring.fredd90 wrote: ↑Sat Dec 11, 2021 8:40 pmDo you use software from Johu or Damien?P.S.Mangelsdorf wrote: ↑Sat Dec 11, 2021 7:34 pm Alright so I've got my PCS wired up and no luck yet. Question: Do I need to change the PIN setting, and if so where do I find what my PCS needs?
Have you followed the pinout in pdf at page one of this thread? I did my work on an original batterypack so i got the original cable with markings on each line.
Seems like the US and EU version got the same pinout.
I'm not referring to the pinout. In the web interface, under the Version heading, there is a setting labeled PIN with a string of numbers. Does that setting need to be changed for each PCS?
The pin is just for the activation of the software, nothing to do with pcs, when I first started my controller the code was 8 numbers with comma. Then I got a new updated firmware.
Regardless it should work 5min without pin.
We still have some month of work left before it will work flawlessly i think.