GS 450H Web Interface
-
- Posts: 87
- Joined: Sat Nov 14, 2020 9:00 pm
- Location: Toronto
- Has thanked: 1 time
- Been thanked: 8 times
- Contact:
GS 450H Web Interface
Can the GS450H VCU Web interface with all the Parameters be access using Version V3_user.ino Software?
I'll figure this out sooner or later
- Jack Bauer
- Posts: 3563
- Joined: Wed Dec 12, 2018 5:24 pm
- Location: Ireland
- Has thanked: 1 time
- Been thanked: 87 times
- Contact:
Re: GS 450H Web Interface
As explained in the video all except current and power are functional as these would require the isa shunt to provide this data.
I'm going to need a hacksaw
-
- Posts: 87
- Joined: Sat Nov 14, 2020 9:00 pm
- Location: Toronto
- Has thanked: 1 time
- Been thanked: 8 times
- Contact:
Re: GS 450H Web Interface
Thanks for the reply,
But I must be asking the wrong question.
I see in other videos where You and Johannes changes settings. Where you adjust offsets, Charge currents, etc.
Are those setting/parameter available for the GS450H VCU?
I hope i make sense.
But I must be asking the wrong question.
I see in other videos where You and Johannes changes settings. Where you adjust offsets, Charge currents, etc.
Are those setting/parameter available for the GS450H VCU?
I hope i make sense.
I'll figure this out sooner or later
- Jack Bauer
- Posts: 3563
- Joined: Wed Dec 12, 2018 5:24 pm
- Location: Ireland
- Has thanked: 1 time
- Been thanked: 87 times
- Contact:
Re: GS 450H Web Interface
Quote from the wiki :
This firmware is intended as a stop gap measure before a new Openinverter based version with a web based interface becomes available. (expect mid 2021).
This firmware is intended as a stop gap measure before a new Openinverter based version with a web based interface becomes available. (expect mid 2021).
I'm going to need a hacksaw