Help! According to data sheet I have 3 phase synchronous permanent magnet motor with 8 poles. Apart from 3 phase wires I have 9 other small wires coming out inside two separate leads. One lead has 4 small wires (which are a touch thinner than the wires in the other lead) and the other lead has 5 wir...

https://github.com/latonita/arduino-canbus-monitor Above is the arduino sketch and libraries that turn arduino and mcp2515 into a socketCAN useable device (using can232/Lawicel protocol). Same wiring of nano and mcp2515 as for canhacker software. It is necessary to set the correct can bus speed in t...

Are you able to read CAN from the car at all? After excruciating 3 day effort trying 4 laptops etc I was able to get SavvyCAN software to run on exact same setup like yours - arduino nano and MCP2515 can bus shield. And it was actually very simple when you know what to do. It only works on a comput...

Are you able to read CAN from the car at all? Yes I was able to read CAN messages from the car same way like you did. But I was not able to light any lights on my digital lcd instrument cluster screen even though I found couple codes - one for gear shifter and another for hazard lights. Interesting...

https://i.ibb.co/vLhVdPJ/20201020-200823.jpg I tried the same with my dash but I got absolutely no response although my ECU is missing at the moment. I was able to find a CAN message for my hazard lights but when I sent it directly to my dash screen I got no response whatsoever. It is a whole lcd d...

Hi. Anybody has an arduino code to send multiple messages to the can bus? Also any idea where to start for a novice on the savyycan? Thanks

Isaac96 wrote: ↑Thu Sep 17, 2020 10:39 pm You need to click the little clicky boxes to the right of the parameter names, that selects the variables to graph or plot

That was it, thank you!

Hi. I just freshly programmed olimex esp8266 wifi and prius gen 3 board. I have not yet got a prius inverter to put the board in. On the web interface I get default parameters to load up. However when I try to open gauges or data logger it just opens a blank page. Does the board need to be in the in...

Hi. On Prius gen 3 inverter v1c board there are two connectors conn3 and conn5. I understand conn3 is to enable dcdc converter when pins are shorted? What is conn5 and how it should be wired - are conn5 pins supposed to be shorted as well? Thanks

Hi. Does the Prius gen 3 inverter with v1c board need any sort of feedback from battery BMS to run? Will it run off a battery without BMS at all or is configurable to do so? Thanks

Hi. Would somebody be able to tell what is the difference between Damiens Prius gen3 inverter boards V2 and V1c? Which one do I need for gen3 inverter?