We need wiring info and pictures of your setup.


Thank you. I started drawing a connection diagram and checking the necessary signals on the inverter contacts. It turned out that I had mistakenly connected the +12 volts to the RSDN.

Now everything is fine, the motor started to rotate.


Note ...

Scrappyjoe wrote: ↑Mon Feb 23, 2026 8:49 am
My test set up (Zombie, Outlander RDU, IVT) runs fine on 2.30.

Could you post your settings file for version 2.30a.
I'll try to compare the settings; I might have made a mistake somewhere.

parameters potnom, pot, pot2 and torque

evMacGyver wrote: ↑Mon Feb 23, 2026 10:36 am When you press throttle, pot and pot2 are getting higher, right? And how about potnom and torque, does those change value too?

recorded a graph of parameters potnom, pot, pot2

Hello there. You managed to get into RUN mode, so your IVT Please clarify. Is this the resistance when there is 12v applied to the system (I/e it is on) or when it is disconnected (I/e it is off)?



Yes, of course, I took measurements without power.

59 ohms is the total resistance in the CAN ...

Thank you very much.
Apparently, I couldn't attach files without the administrator reviewing my first message.

Hello,

I need help getting my Outlander Rear Inverter running under zombieverter.

I couldn't get it running on version 2.22a, so I updated zombieverter to version 2.30a, which didn't work.
Connecting a different inverter also didn't work.

Parameters INVudc, tmphs, tmppm the receive stably from ...