I have one I'm not using, make me an offer.

Runs at 600v looked plenty powerful.

I Have one, based in Oxford, or could post?

Very professional looking project, can't wait to see how much power you can get out of it.

Great solution, and less noise.

m.art.y: ordered 40kw leaf battery, arrived in great condition and a good price. Good communication.

thx for the reply, yes all the grounds connected. Both inverters draw about 1.1 amps. I think next step is to check inverter 32pin block, I found it difficult to insert some of the pins.

Just tried a second inverter, same results..

Before i dismantle all my wiring and start again, does the lead coming from the interlock terminal need to be connected to anything?

Cheers

Rich

Just checked it pulls 1.2amps on the main inverter power connector. I have ordered another inverter anyway just to see if results are different.

ok its powered from a well charged Battery, so probably blown..
Thx for the help.

thx for the reply, it is connected ,just to make sure i removed the original connector and changed it for a few bullets. Same results. The only thing that's slightly different from the video, is the 12v bulb in line with the battery does not light up when inverter is powered on, there is some slight...

Hi all, Just going through initial set up of gen 2 board. i'm going through tutorial video, My knowledge is basic so please bear with me.- I have connected 12v and have led's lit one flashing I am logged on to wi-fi interface I have connected about 100v to DC input- light flashes once, as it should ...

Great Idea, i could use the ac inverter for single phase charging, MG1 for three phase charging, and MG2 for Motor. Any idea of the power of the ac inverter? 3KW?

Hi

Put me down for 30 modules

Hi Guys, I have a gen2 inverter. I'm going to drive a hvh250 remy core with it, is it possible to charge a 350v pack with this? In boost mode would i have to make any hardware changes or is it controlled in the software? Thanks in advance.