Openinverter has 2 analog inputs, You can only configure them two ways: 1) Use both analog inputs for a dual output throttle. 2) Use one for the throttle and the other for a brake pressure sensor. Assuming you have a dual pot throttle, and no brake pressure sensor, you should connect both throttle ...

What have you wired up, please show us? did you wire the 4 pin position sensor? eventually got it working. seems that the wiring of the toyota is a bit different. it also has a different connector compared to other gen2 iboosters. the wiring should be the same as other gen2 iboosters, except the se...

I too bought a iBooster GEN2 but from a yaris. Mine does not assist at all. CAN messages are transmitted by the module and power is supplied properly (first on pin 9. after that on pin 20). Still no calibration starting either. anyone familiar with this problem?

Anyone sure about the part? the one from Proton looked like the right angled one to me as well. If nobody has been able to find one i might as well print one. let me know