Ive used copper tape with conductive adhesive. I put down about an inch of tape then quickly solder the wire onto it. a little hot glue on top for good measure..
Gadget
Search found 3 matches
- Sat Jul 08, 2023 1:26 am
- Forum: Tesla
- Topic: Battery module help!
- Replies: 11
- Views: 846
- Mon Oct 31, 2022 6:44 pm
- Forum: Tesla
- Topic: Tesla Charger Support Thread
- Replies: 785
- Views: 129162
Re: Tesla Charger Support Thread
It is powered with 12 volt from the key switch circuit. This is my second board. the first one is running perfectly. I've swapped this board into the other charger and it had the same problem.
- Wed Oct 26, 2022 5:22 pm
- Forum: Tesla
- Topic: Tesla Charger Support Thread
- Replies: 785
- Views: 129162
Re: Tesla Charger Support Thread
I have a gen 2 logic board V5aB3. The board works fine when it boots, but I have it restart it several times to get LED1 to start blinking. I found in an earlier post that you could fix that with a jumper on CONN4 . but that was an earlier board, this version does not have that. does anyone know a f...