Any idéers where I can get a an inverter or inverter card please let me know...

Interesting to see. I don't have a picture from the right angle before I tested it but the jelly has the same type of bubbles now

Found one suspicious igbt, see picture.
Anyone have spare igbt's or know where I can buy a new one? And any one know where I can buy the jelly...?

I got it from a salvaged car i Norway.
You know were I can find a separate inverter? I presume it's no ide to try to repair or what do you think?

Have had some good test run att 55Volt.
Tested 110Volt and got into a problem. At 7000rpm the DC minus cable fuse blow at 25 amp...motor made a jerk and stoped functioning (DC bus down). One led ( pen pointing at) on the inverter card on the picture lit up.
When I try to restart and set ut to ...

My mistake...lowered udcswbuck instead of udcmin.
Now it is turning but only at less than 1rpm. Board is installed in a stock LDU 2013 P85 Sport, is this the speed sensor that has to be repinned to make it work?

dir changes to FORWARD and at the same time lasterr changes from TORQUE to CURRENTLIMIT.
potminimun is 520 dig.
pot is following throttle from 400 to 2000 when I'm pressing it.
Will try to plot but Web interface isn't very stable...

Yes, I can get it into RUN and activate Forward and apply volt to the Pedal input. I can see that the pot value changes to high value than the potmin value and the sound of the inverter respond to the throttle change...
I'm a bit puzzled.

Well, everyting looks right (as far as I can understand) on the Web interface and I can hear the inverter work as I press the pedal but it doesn't turn.
Will continue on Tuesday night.

Hi!
I have a ready built board that is installed in LDU and connected to 54Volt.
I can get it into RUN and activate Forward and apply volt to the Pedal input but the motor doesn't move. I can see that the pot value changes to high value than the potmin value.
Can I expect it turn with 54Volt ...

Okay, sorry but I'm trying to find my around. Thanks for your reply's!

Well I have seen it but feel it is very limited...would like a complete list :-)

I bought a fully build and tested Tesla LDU card and am trying to get it up and running.
So far I connected Ignition 12V, ground, start button.
I don't get it to respond to the start signal, I can only activate it ...

Where do I find a list of the parameter description?
Thanks!
Peter