Hi Damien, Just wondering if you realize that the pin numbers on the drawing of the Toyota 40-pin header are not the same as the numbers on the back of the header? On my header (on a 2010 Toyota Crown hybrid inverter, part number G9200-30070) pin 1 is where you have pin 32 and vice versa. Please cor...

Has anyone yet put an electric clutch on the spline of the transmission to lock the shaft, instead of locking it permanently? Then one would be able to utilize the internal mechanical oil pump by releasing the electric clutch and driving the vehicle only from MG2. This would save the use of the elec...

Hello Johannes,
Will your Prius Gen 2 controller board drive a Camry Hybrid AVV50R inverter?
Have you modified it to make 3-phase AC?
Where does one get the 3-phase neutral from (or the single phase neutral, for that matter)?
Thanks for a great set of videos.
Regards,
Ian

https://openinverter.org/forum/download/file.php?id=2077 please forgive my ignorance but could someone spell out these acronyms for us Pins 4 & 8 are MMTG & MMT respectively for MG2 (or GMTG & GMT respectively for MG1) which are for temperature sensing by the Zombieverter board, and I g...

https://openinverter.org/forum/download/file.php?id=2077 please forgive my ignorance but could someone spell out these acronyms for us M at the beginning is for the MG2 resolver G at the beginning is for the MG1 resolver SN is for sine CS is for cosine RF is for resolver frequency (I think), meanin...

Here's my simple implementation. Two posts made out of 3/4" diameter brass rod machined down to 16mm, each with a 6mm hole for the bolt. A 55 x 30 x 20 block of polypropylene foam cut with a sharp scalpel into an oval shape slightly larger than the hole in the inverter with two 14mm holes of ce...