I am after a outlander rear drive inverter

Outlander LEV40 modules https://www.ebay.co.uk/itm/334570799511 These are mine and i used them to test my setup before i brought a bigger capacity setup, not looking to make a profit just get my money back, I travel down to birmingham fairly regular so could possibly deliver or meet up between Scotl...

EV_Builder wrote: ↑Fri Jun 24, 2022 5:10 pm

EV_Builder wrote: ↑Mon Jun 13, 2022 9:12 am Would there be interest if i would realize an nice module with housing for this interface?

Does someone have a slave board for me?

sorry i do not have any spares

Sorry for the delay cannot post files on the forum so i have uploaded it to drop box link is below. I am still working on the version using the SIMPBMS code and 'aot93' board. My goal is to get the BMS working with the outlander charger and a CAN current sensor. I have currently blown my teensy boar...

Chris - I notices that you have had one of the boards off one of the batteries, did you work out what cells contact to what pins. Is it a straight C0 to C6 or are they gaps? Also, do the batteries have one or two thermistors. Thanks Yes these modules use the first 6, although the code I have writte...

Chris - I notices that you have had one of the boards off one of the batteries, did you work out what cells contact to what pins. Is it a straight C0 to C6 or are they gaps? Also, do the batteries have one or two thermistors. Thanks Yes these modules use the first 6, although the code I have writte...

Hello I have a complete e208 battery pack and wanting to use it with my victron setup so i am after something like the Simpbms, i am not that good with Arduino IDE but i can design, manufactured, assembled PCB through my work, so if i can be any help let me know or i would be interested in what you...

looking at the connecter starting pin 1 top left, 6 top right ,7 bottom left, 12 bottom right pin 10 TX1, pin5 TX1 pin 6 RX1, pin12 RX10 Pin1 TX2 (next module), pin7 TX2 (next module) Pin3 RX2 (next module), pin8 RX2(next module). to daisy chain modules: pin 1 connect to pin 12 of the next board pin...

I am just away on holiday but can supply the pin out when I get back. I asked the breaker to supply the comms cable from the donor car, small things like that can really help

Yes they use a max17823 chips which other manufacture's have used, There is a max17841 interface chip which make interfacing allot easier. data sheets arfe easy avala ble if you google the chip numbers. Also have a read through this https://openinverter.org/forum/viewtopic.php?p=20335#p20335 I got o...

I was getting series error on my Simp BMS and all cell where present and correct, it was basically because I was not saving the setting's. i think if I remember correctly the setting's are saved when you exit back to the root menu. I know Tom is the designer so he knows best but this was just down t...

These CATL modules are using a MAX17823B chip.
Data sheet is available for it seems to be a dedicated BMS chip.
Looking at the loom its wired in a daisy chain.

Has anyone interfaced to these before ?
Might just save me some work

See images attached

I assumed all manufacturers where putting the bms on the modules now and saw some advertised on eBay, which stated bms on board

Has any work been done to interface to the BMS on these?

CATL Battery Module 2P6S 2.74kWh 21.9v 2737Wh

taken from Peugeot e-208

I am wanting to use the rear motor and invertor i can see people has got the motor & invertor running but does the rear motor do regen and have any of the commands been found?