USB connector was already there. Arduino IDE recognizes the board and I can upload stuff there.EV_Builder wrote: ↑Sat Nov 13, 2021 2:42 pm Ok so you opened up the cover and soldered in the USB connector and plugged in the laptop?
Search found 3 matches
- Sun Nov 14, 2021 2:05 pm
- Forum: Tesla
- Topic: Tesla Charger Support Thread
- Replies: 785
- Views: 129209
Re: Tesla Charger Support Thread
- Sat Nov 13, 2021 1:23 pm
- Forum: Tesla
- Topic: Tesla Charger Support Thread
- Replies: 785
- Views: 129209
Re: Tesla Charger Support Thread
Board worked out-of-the-box when installed in the charger but we could never configure its parameters. Can you elaborate on that sentence? Sure thing. It was bought directly from Damien two years ago, I think. It was never configured by anyone (except Damien) but installed directly inside a gen2 ch...
- Sat Nov 13, 2021 7:24 am
- Forum: Tesla
- Topic: Tesla Charger Support Thread
- Replies: 785
- Views: 129209
Re: Tesla Charger Support Thread
Hello, I have a v3 logic board in my hands. It doesn't output anything to serial monitor. In Arduino IDE I've compiled v3 and v4 code and both upload fine to the board but serial monitor stays blank. Speed is set to 115200. Putty throws error message when trying to connect to the board. Board worked...