a synchronous economical and high-speed electric motor spun. but there are interruptions in work. it is necessary to adjust the voltage and restore 5 volts on the plate, as well as the table of settings of this program is needed for this electric motor

I compared my electric gear motor from Lexus RX400h, it weighs 50 kg and it is 50 kW, and the electric gear motor from Nissan Leaf, it weighs 103 kg and 80 kW. I do not need such a weight on an additional auxiliary electric motor, I will have enough power and it will be noticeably more economical. I...

I put the drive on one-way bearings, so that with a welded differential forward 2 wheels without slipping pulled in any conditions, snow, mountains, diagonal hanging, and on turns the far wheel overtakes due to free travel on one-way bearings. I accelerated to 120, nothing rattles, no vibrations, th...

Магниты АБС и курсовой устойчивости.

Муфты обратного хода- односторонние подшипники.

Wow, technologically advanced. Neat jumpers. I almost put the drive cut and through the rubber couplings connected to the overrunning bearings one-sided 2 pieces for each drive. soon I'll show you a photo, all-wheel drive hubs and external shruy I already put on the Toyota Avalon front-wheel drive f...

Of course, my trunk will turn out to be so small. I can put 2 suitcases and 2-3 small bags in it, and this is enough for me. But I rarely do this 4 times a month, and I have a trailer device for large and oversized loads. And I drive 20-30 km every day. On electricity at the night rate, it is 15 tim...

Wow. Such batteries from Ford Fusion Energy at 7.6 kWh in Georgia cost $ 500. I got it for 256 dollars from a working disassembled car in 2015, with a mileage of 85,000 km. I had to go 150 km for it and quickly buy it. This is my 20-40 km run on pure electric, I don't need any more, 100% charging ti...

I'm looking for someone to pay for money, transfer to a bank card, via video link, help set up the inverter. everything is connected, there is a pre-charge, the gas pedal is active. I don't need brakes and recuperation, but the signal from the brake contact was brought to the inverter. if the langua...

Hello everyone. The inverter was started from 12 volts, the Wi-Fi works, the gas pedal was set up as needed. We have a question. What are the parameters for the inverter for my engine, as a person wrote in my category parameters for my Lexus RX400h engine. Do I need to change them? And I will not ha...

.

Wow, how cool Mikmur turns out to be able to figure it out. And such a competent electrical circuit. Very cool. On Saturday, we rent a lift, take different capacity batteries for testing and start the first turn of the motor. Many people in Georgia have not heard or seen that it is possible to do th...

Hooray for one-way rolling bearings from China. I will put them on 2 for each cut wheel drive. 2 each for alignment and high rpm. I will also order a non-difficult design from the turner from a pipe housing for bearings, into which I will pump transmission oil. I welded the differential. So I came u...

According to the Booster, I will say that a good person Konstantin from Belarus helped me. The fact is that despite the fact that Demian anthropological August-Avrei-Abel's blood and my blood, you can see it in the face and even the fingers of the hand if you compare it. And MaGudAvARrer worked hard...

Colleagues, friends of the electron. Tell me please. This inverter podderdivaet redim Boost, which is made from my battery 244.8 volts 650 in peak modes? I think it is necessary not to combine the batteries, let the hybrid itself runs on NiMH, only 1.6 kWh, and on this second bridge I think to put a...

It's more comfortable for the leg. Nothing prevents you from working separately with 2 gas pedals. I'm not comfortable with 2 gas pedals on one foot at all. Since if I put the main hybrid powerplant in neutral, I'm driving on the rear axle electric motor alone and all the appliances will work. And i...

Who will say what about this 7.6 kW Lithium battery from Ford Fusion Energy plug-in 2014. I found 2 of these pieces for $ 500. It weighs about 100 kg. I think it will be enough for me for 40-50 km, I don't need more, there is a hybrid system with a power reserve of 1800 km, and I drive an average of...

The fitting of the second inverter was successful, but the wires are not connected yet, there are no support mounting strips. But the main thing is that I entered the prepared place. The corner was removed by the manufacturers, who made it specially for me.

I have an Electric+ hybrid gasoline-LPG. And here are also 2 traction systems on different axles electric and diesel. Says a lot of power too the diesel 2.5 needs 1.9 for the combined system. https://electroavtosam.com.ua/forums/vi ... =26&t=1039

It turned out that the Inverter came with a socket for 2 thick power contacts from a high-voltage battery, a 3-phase socket coming from an electric motor, 10 wires from an electric motor control, a resolver and a temperature sensor, 1 thick power wire for pre-charging and 2 small contacts with it. 4...

Я живу в Батуми привез себе 2 машины гибридные из США. Не имея гражданства ГруЗии, и расстаможил их на Грузию и поставил на учет прямо на себя, получив обычный ИНН. Тут растаможка на Тоету Авалон 2016 гибрид 400 дол, а Хонду CR-Z 2012 гибрид 270 дол. Но можно и делать транзит машины, а в Россию ввоз...

Well, I fully pushed the place for the second inverter. I brought 2 cooling pipes, directly with latches for the inverter, which passed through an additional radiator, a tank of cooling liquid and through the pump, from which I also brought out the wires. I brought the wiring 3 krntakta from the gas...

2 gas pedals, under the knife, a little higher on the left, does not interfere with anything, it is convenient to press, far from tortosa. Just take off your left foot from the stand and press the toe of the shoe, without interfering with anything. Wires from it 3 pieces and 1 exit from the gas peda...

Кто понимает эти настройки Лексус RX400h? Подскажите пожалуйста какие параметры изменить? Мне нужно рекуперацию на этом заднем мосту вообще убрать, у меня передний мост эти функции выполняет, нужен свободный накат, что изменить? Оборотов у меня максимально 11400 дает этот электромотор-редуктор. Как ...

Midway привет. Спасибо большое за советы умные. Но датчики тока стоят на длинных шинах наверху на белой планке, у самого выхода из инвертора. А мы соединяем 3 фазы внизу, до датчиков тока и вместе они уже соединенные 3 фазы выходят проходя по толстой шине через датчик тока на МГ2. По усиленному потр...