Main Page: Difference between revisions
Jump to navigation
Jump to search
| Line 32: | Line 32: | ||
* [[Configuration Files]] | * [[Configuration Files]] | ||
* [[Battery Charging]] | * [[Battery Charging]] | ||
* [[Features]] | |||
= Inverter Kits = | = Inverter Kits = | ||
* [[ | * [[Using FOC Software]] | ||
* [[Schematics and Instructions]] - for the "vanilla" inverter kit. | * [[Schematics and Instructions]] - for the "vanilla" inverter kit. | ||
* [[Toyota Prius Gen2 Board]] | * [[Toyota Prius Gen2 Board]] | ||
Revision as of 07:32, 6 February 2020
Welcome to the openinverter.org Wiki Site.
Everyone registered at the forum can login here with the same username and password and can make changes.
The open inverter project consists of some reference designs for the control hardware using an STM32F103, the inverter firmware, and an easy to use web interface. Other hardware variants include drop in boards for Tesla small and large drive units.
If you have received a kit you are probably looking for build instructions.
If you want to tune your inverter check the parameter description.
You might also want to set up CAN communication or use the inverter as a battery charger also.
Hardware
- Main Board Version 3
- Main Board Version 2
- Main Board Version 1
- Sense Boards
- Gate Driver
- Hardware Theory of Operation
- Legacy Sensor Board
Software
- Software Theory of Operation
- CAN communication
- Web Interface
- Parameters
- Downloads
- Errors
- Configuration Files
- Battery Charging
- Features
Inverter Kits
- Using FOC Software
- Schematics and Instructions - for the "vanilla" inverter kit.
- Toyota Prius Gen2 Board
- Toyota Prius Gen3 Board
Tesla Boards
Ford Ranger TIM inverter
- Introduction
- Schematics and connector pinout
- Modifications to original wiring
- Hardware installation
- Where to buy