Main Page: Difference between revisions
Jump to navigation
Jump to search
Kevin Sharpe (talk | contribs) |
Kevin Sharpe (talk | contribs) |
||
| Line 45: | Line 45: | ||
* [[CAN table CAN STD|CAN table]] | * [[CAN table CAN STD|CAN table]] | ||
= Tesla Boards = | = Open Inverter Tesla Boards = | ||
* [[Introduction Tesla|Introduction]] | * [[Introduction Tesla|Introduction]] | ||
* [[Files Tesla|Schematics, pcb layouts, BOMs and Gerber files]] | * [[Files Tesla|Schematics, pcb layouts, BOMs and Gerber files]] | ||
Revision as of 21:15, 21 February 2020
Welcome to the openinverter.org Wiki Site.
Everyone registered at the forum can login here with the same username and password and can make changes.
The open inverter project consists of some reference designs for the control hardware using an STM32F103, the inverter firmware, and an easy to use web interface. Other hardware variants include drop in boards for Tesla small and large drive units.
If you have received a kit you are probably looking for build instructions.
If you want to tune your inverter check the parameter description.
You might also want to set up CAN communication or use the inverter as a battery charger also.
Hardware
- Main Board Version 3
- Main Board Version 2
- Main Board Version 1
- Sense Boards
- Gate Driver
- Hardware Theory of Operation
- Legacy Sensor Board
Software
- Software Theory of Operation
- CAN communication
- Web Interface
- Parameters
- Downloads
- Errors
- Configuration Files
- Battery Charging
- Features
Inverter Kits
- Using FOC Software
- Schematics and Instructions - for the "vanilla" inverter kit.
- Toyota Prius Gen2 Board
- Toyota Prius Gen3 Board
- Lexus GS450h Inverter
Open Inverter CAN std.
Open Inverter Tesla Boards
Ford Ranger TIM inverter
- Introduction
- Schematics and connector pinout
- Modifications to original wiring
- Hardware installation
- Where to buy