Page 1 of 1
Canbus
Posted: Mon Apr 20, 2020 5:27 pm
by zippy500
Is there how too /setup , If Can input signals are used (throttle etc) how are these signal inputs configured to the V3 board ?
I don't have much knowledge on Canbus signals
Re: Canbus
Posted: Mon Apr 20, 2020 5:48 pm
by Kevin Sharpe
zippy500 wrote: ↑Mon Apr 20, 2020 5:27 pm
Is there how too /setup , If Can input signals are used (throttle etc) how are these signal inputs configured to the V3 board ?
Always start a knowledge quest with the wiki
https://openinverter.org/wiki/CAN_communication
Re: Canbus
Posted: Mon Apr 20, 2020 6:01 pm
by zippy500
ok Thanks, will take a look