openinverter forum

Posted: **Tue May 27, 2025 9:17 pm**

Hello,
I am sure I'm missing something here but when opening a "New CAN Mapping" window the parameter list shows only "No Options".
Please Help.
I tried with Safari and Firefox.
I am using a ZombieVerter VCU V1a Firmware v2.22A; Web Interface : v2.0; Wi-Fi ESP8266

Posted: **Wed May 28, 2025 6:03 am**

Odd. Are the parameters/spot values showing?

Posted: **Wed May 28, 2025 10:48 am**

Yes, they are all here.

Posted: **Wed May 28, 2025 7:57 pm**

The list disappear when the FlyingADC BMS (on CAN2, IVT Shunt on CAN1) is powered and enabled at the same time as the ZombieVerter is powered.
The list and saved CAN mappings reappear after one or two webpage refresh.

openinverter forum

Interface issue. CAN Mapping Spot Value/Parameters not loading.

Interface issue. CAN Mapping Spot Value/Parameters not loading.

Re: Interface issue. CAN Mapping Spot Value/Parameters not loading.

Re: Interface issue. CAN Mapping Spot Value/Parameters not loading.

Re: Interface issue. CAN Mapping Spot Value/Parameters not loading.