openinverter forum

Can someone give an example of how I start the inverter via canbus, or switch the direction D N R, would like to install a nextion display, which I use to control the whole thing??

You need to read and understand this https://openinverter.org/wiki/CAN_communication

Start signal starts, forward/reverse selects direction

This no longer works starting v5.32.R! See above!
So it no longer works that you can start the drive direction or the inverter via canbus???

Yes it does. Read again

oh my god, wenn das nur auf Deutsch wäre

https://openinverter-org.translate.goog ... r_pto=wapp

It's a bit over-translated Cruise=Kreuzfahrt

Now with throttle pre defined,

Is controlling an inverter board via a zombieverter over can as simple as setting control to can and that’s it?

I'm guessing by now someone has implemented it on the Zombie side. On the inverter side no mapping is needed, only can speed needs to match