openinverter forum

FYI, I just published an STL on Thingiverse for 3D printing a replacement SDU MX150 Female Connector. This part is very brittle and tends to break easily. As far as I know, replacements are unavailable, so I decided to make my own. It screws right into the aluminum case, and there is no need for the blue retaining clip. I've printed a few so far and they seem to work well, so I decided to share. I recommend using ABS/ASA filament, 100% infill, and a .25mm nozzle for best results. Takes about 10 hours to print on a Prusa MK3S.

Please let me know what you think, and enjoy!
https://www.thingiverse.com/thing:6230844

Awesome
Want to link it on the wiki?
https://openinverter.org/wiki/Tesla_Mod ... %22SDU%22)

added.