Using 5.24r
I've battled for a few hours to get the values i want sent in can messages. I want to receive id & iq, and i did have il1 & il2 mapped but not sure these are as useful so tried to swap them out.
I've tried to delete the il1 & il2 mappings and use the same can id etc for id & iq. I can unmap il1 & il2 and save the params and even map id & iq, but il1 & il2 keep returning when i issue a 'can print' command. I've tried different combinations of saving parameters and restarts but i can't get what i want to stick.
I've tried can clear, and entering all from scratch but get the same. It is as if these variables are somehow overlayed in the code, maybe a cut & paste issue or have i misunderstood something ?
Mapping can messages
-
- Posts: 321
- Joined: Mon Jul 25, 2022 7:59 pm
- Location: Bicester, Oxfordshire
- Has thanked: 8 times
- Been thanked: 46 times
Mapping can messages
E46 touring
Phev rear motor, OEM inverter cabin heater and charger
BMW 9kwh & 12kwh packs
Phev rear motor, OEM inverter cabin heater and charger
BMW 9kwh & 12kwh packs
- johu
- Site Admin
- Posts: 5786
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 157 times
- Been thanked: 1021 times
- Contact:
Re: Mapping can messages
Yes, will draft a new release soon that fixes it!
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
-
- Posts: 321
- Joined: Mon Jul 25, 2022 7:59 pm
- Location: Bicester, Oxfordshire
- Has thanked: 8 times
- Been thanked: 46 times
Re: Mapping can messages
thanks - compiling the code is beyond my skills, especially as I'm a WIndows kind of guy
E46 touring
Phev rear motor, OEM inverter cabin heater and charger
BMW 9kwh & 12kwh packs
Phev rear motor, OEM inverter cabin heater and charger
BMW 9kwh & 12kwh packs