Hello Forum.
My first post here so a quick intro....
I am using the Enova 3ph 90Kw motor coupled to the Enova power stage with the Damien/Johannes Combi V8 board and Johannes Olimex board running v4.87 software.
Not sure what to set the parameters to ?
I wish to use the full rpm range, max 9000rpm, motor rated voltage 208v.
DC bus voltage at present is 230v most probably will be increased to 280v later once I am rolling.
If anyone is based in the North West UK please say 'hello' too Maybe a chance to meet and greet fellow DIY enthusiasts.
All the best.
My first post here so a quick intro
- Peter
- Posts: 310
- Joined: Fri Dec 14, 2018 9:07 pm
- Location: North West Lancs, UK
- Been thanked: 8 times
Re: My first post here so a quick intro
Hello 2013coss.
I see from your message you based in the North West. If so which town please? I am in Blackburn. All the best. Peter
I see from your message you based in the North West. If so which town please? I am in Blackburn. All the best. Peter