can bus man in the middle question
Posted: Sat Jun 04, 2022 10:29 am
It is the firs time i try to produce a PCB, and i choose JLCPCB to produce the "can bus man in the middle" design from Damien.
I sent the gerbers as published in the GIT , but JLCPCB is asking me something i dont understand because my zero electronic knowledge.
I ask if somebody can help me what they are answering to me:
....
1.We are not sure the layer stack up. Should we make VCC= L2 and GND=L3 to proceed?
2. for the 4 big holes at the corner, should we make them as plated hole or non-plated holes ?
I sent the gerbers as published in the GIT , but JLCPCB is asking me something i dont understand because my zero electronic knowledge.
I ask if somebody can help me what they are answering to me:
....
1.We are not sure the layer stack up. Should we make VCC= L2 and GND=L3 to proceed?
2. for the 4 big holes at the corner, should we make them as plated hole or non-plated holes ?