Intermittent failures

Post Reply
yaroslav
Posts: 176
Joined: Tue Aug 13, 2019 4:32 pm
Location: Russia, Stavropol
Has thanked: 14 times
Been thanked: 5 times

Intermittent failures

Post by yaroslav »

Hello. I ask for help from the forum, I have collected a board for my project, the circuit is in the application and sometimes I encounter malfunctions, but they do not occur often, these failures lead to periodic through current and if the engine turns, it is not possible to unwind, there is a floating of revolutions, then this problem disappears as if it did not it was, and the engine accelerates normally and there are no failures. Firmware sine 5.15
Attachments
crop_pdf_Logic-500A-Main-DOCS-2021-04-19_628159fe67f3c.pdf
(1.84 MiB) Downloaded 109 times
User avatar
johu
Site Admin
Posts: 5681
Joined: Thu Nov 08, 2018 10:52 pm
Location: Kassel/Germany
Has thanked: 153 times
Been thanked: 959 times
Contact:

Re: Intermittent failures

Post by johu »

Circuit diagram is pretty much standard openinverter and there is no known problem like that. Could it just be an issue with encoder or gate driver connection?
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
yaroslav
Posts: 176
Joined: Tue Aug 13, 2019 4:32 pm
Location: Russia, Stavropol
Has thanked: 14 times
Been thanked: 5 times

Re: Intermittent failures

Post by yaroslav »

Yes, the circuit is very similar, but there are a few differences, quartz is connected through a 2k resistor and the 60 pin is not at minus, but through a 10k resistor, if this cannot be the cause, then it looks very similar to the problem with the encoder, because the reason disappeared last time after I twisted the same one the same encoder from one engine to another
Post Reply