SimpBMS V2.3/2.4 Printed Housing

Topics concerning OEM and open source BMSes
Post Reply
tom91
Posts: 1273
Joined: Fri Mar 01, 2019 9:15 pm
Location: Bristol
Has thanked: 97 times
Been thanked: 202 times

SimpBMS V2.3/2.4 Printed Housing

Post by tom91 »

A couple of people have asked about a 3d printed housing or a housing in general for the SimpBMS.

I have drawn one up, it comes in two pieces a bottom and a cover. It is deigned to work with drg-01 din mounts if so desired.

The top half just fits snug on the bottom so no true "fixings" are used. The SimpBMS is held into the base with 4 No.2 selftapping screws.
s-l300.jpg
s-l300.jpg (8.47 KiB) Viewed 927 times
20220331_170211.jpg
20220331_170348.jpg
20220331_231120.jpg
Attachments
Simp Top Housing.stl
(572.25 KiB) Downloaded 177 times
Simp Bot Housing.stl
(626.94 KiB) Downloaded 141 times
Founder Volt Influx https://www.voltinflux.com/
raine
Posts: 37
Joined: Sun Jun 27, 2021 10:35 am
Has thanked: 4 times
Been thanked: 6 times

Re: SimpBMS V2.3/2.4 Printed Housing

Post by raine »

Thanks Tom. Good work.
alexbeatle
Posts: 141
Joined: Sun Jan 03, 2021 6:12 am
Has thanked: 40 times
Been thanked: 13 times

Re: SimpBMS V2.3/2.4 Printed Housing

Post by alexbeatle »

Great work, Tom. Thank you.
Post Reply