Page 1 of 1
Tesla Model 3 Drive Unit Model / 3D Scans
Posted: Wed Jul 21, 2021 10:34 am
by nkiernan
Does anyone know if there are detailed/accurate 3D models or scans of the Tesla Model 3 front and rear drive units that would work in Solidworks? It's been discussed on the forum a while back and there are some basic scans on Grabcad, but checking if there is anything more detailed available since.
Re: Tesla Model 3 Drive Unit Model / 3D Scans
Posted: Sat Jul 24, 2021 12:03 am
by paaa
If anyone has access to one I can gladly do some rudimentary scanning with my structure sensor.
Re: Tesla Model 3 Drive Unit Model / 3D Scans
Posted: Sat Jul 24, 2021 6:47 am
by Jack Bauer
I have one
Re: Tesla Model 3 Drive Unit Model / 3D Scans
Posted: Sat Jul 24, 2021 11:25 am
by nkiernan
Got rough dims from the grabcad model and mocked up in 'real' CAD! So no need to try get a scan if not already available. Was just checking, cheers. Interestingly, the TM3 rear drive motor size looks to fit up front ok, but not so straightforward at the rear without changing the angle of the axle shafts.
Re: Tesla Model 3 Drive Unit Model / 3D Scans
Posted: Mon Sep 13, 2021 5:59 am
by EV_Builder
You can convert the grabcad to a SOLIDWORKS solid.
(Import the grabcad in SOLIDWORKS).
In the thread I posted how I did it.