openinverter forum

Hello.

Hello sir.

Any of you good sirs that have encountered a replacement on the Melexis current sensors for the SDU.

One of the ones that came with my inverter broke off. So I have ordered new ones. Question is if they would need to be configured or programmed?

I was thinking this question might be of interest.

https://www.mouser.se/ProductDetail/482 ... ACAA002SP/

Victor Norberg
Currently a Technician at Candela Speedboat - Electric Hydrofoiling boats.

I remember seeing somewhere here that they do not need programming. I'll see if I can find the post again, maybe you can find it too.
-Isaac

I have bought a few of them and they come programmed with a default sensitivity as specified.

Is there an alternative part for these sensors? They seem to be sold out everywhere with long delivery times.