openinverter forum

Can the GS450H VCU Web interface with all the Parameters be access using Version V3_user.ino Software?

As explained in the video all except current and power are functional as these would require the isa shunt to provide this data.

Thanks for the reply,
But I must be asking the wrong question.

I see in other videos where You and Johannes changes settings. Where you adjust offsets, Charge currents, etc.

Are those setting/parameter available for the GS450H VCU?

I hope i make sense.

Quote from the wiki :
This firmware is intended as a stop gap measure before a new Openinverter based version with a web based interface becomes available. (expect mid 2021).