openinverter forum

Just thought Id share I've been working on this today and 3d printed it and test fit it and it fits like a charm. I will be making this for my build and will have either bolts or a center hole for welding the flywheel on, depending if I go steel or aluminum. As I will use it as a mounting point for the transmission and other items if deemed needed.

Nice!

You must have a large format printer for something that size?

sfk wrote: ↑Mon Dec 14, 2020 6:04 pm You must have a large format printer for something that size?

No I just sliced it by .01mm then glue back together after print

Why not just water jet it out of plate steel or aluminum?

TheSilverBuick wrote: ↑Mon Dec 14, 2020 6:13 pm Why not just water jet it out of plate steel or aluminum?

I needed a test fit first - now I will get it laser cut

Hy Gigas

Nice looking adapter plate,

I just realist that I mad a minor mistake on the Drawing of the bolt plattern i posted in this forum.
One hole diameter was not corect.

Mobert wrote: ↑Mon Dec 14, 2020 7:38 pm Hy Gigas

Nice looking adapter plate,

I just realist that I mad a minor mistake on the Drawing of the bolt plattern i posted in this forum.
One hole diameter was not corect.


PLTeec5.jpg

very cool an ez fix

Can you make the 3D file available? I'd be interested in getting one cut for my project.

Attaching some files that might also help. Drawn up from the dimensions above and fits 100%. Includes mounting holes in lower corners.

Thanks for the dxf file!

nkiernan wrote: ↑Sat Dec 19, 2020 7:53 pm Attaching some files that might also help. Drawn up from the dimensions above and fits 100%. Includes mounting holes in lower corners.

DSC_5049_1.gifDSC_5045_1.gifDSC_5050_1.gifDSC_5038_1.gifGS450H-005.DXFGS450H-005.pdf

That spline coupler from the flywheel?

Yes, cut out of the flywheel and cleaned up on the lathe. Bit of approx 63mm OD 8mm wall off the shelf mechanical tube then.

What material did you end up making it with, also what thickness?

6mm mild steel plate.