Page 1 of 1
How wide is your syncofs standstill?
Posted: Wed Sep 30, 2020 6:23 pm
by bexander
How wide can I expect for the syncofs values when manualid set to 100? I get some 1000 points or more where it stand still and I'm thinking, this can't be right. From Damiens video I get that at 10100 it move and at 10120 it stands still but no mention of when it starts to move again? But I still think it should be like 50 points or so?
What is your result?
Re: How wide is your syncofs standstill?
Posted: Wed Sep 30, 2020 9:57 pm
by ZooKeeper
I get no rotation between 10,800 & 11,200 @ 165v and MID <= 75.
Re: How wide is your syncofs standstill?
Posted: Thu Oct 01, 2020 6:21 pm
by bexander
Ok, thanks! That sounds resonable to me.
Re: How wide is your syncofs standstill?
Posted: Thu Oct 01, 2020 7:25 pm
by johu
Might also be good to know that the jitter on a well shielded resolver is still about +-180 digits (+- 1°), so it makes limited sense to tune much below that figure.