EM57 test run with bridge rectifier

Post Reply
User avatar
tom91
Posts: 2962
Joined: Fri Mar 01, 2019 9:15 pm
Location: Bicester, Oxfordshire
Has thanked: 328 times
Been thanked: 847 times

Re: EM57 test run with bridge rectifier

Post by tom91 »

.. bug? It is just you setting a parameter wrong.

Has to do with not spoofing the PDM messages when a PDM is selected. By setting it to another bus, it will break the system as the leaf has all devices on one bus.
Creator of SimpBMS
Founder Volt Influx https://www.voltinflux.com/
Webstore: https://citini.com/
Top
User avatar
tom91
Posts: 2962
Joined: Fri Mar 01, 2019 9:15 pm
Location: Bicester, Oxfordshire
Has thanked: 328 times
Been thanked: 847 times

Re: EM57 test run with bridge rectifier

Post by tom91 »

Rcoetzee wrote: ↑Sat Apr 04, 2026 1:59 pm So yes, charger and inverter were connected to CAN1 but with the auto refresh and somewhat buggy interface on the cellphone it looked like charger param was set to CAN1 but it was in fact not.
Screenshot of the behaviour? Also DO NOT have auto refresh on when setting parameters.
Creator of SimpBMS
Founder Volt Influx https://www.voltinflux.com/
Webstore: https://citini.com/
Top
Post Reply

Return to “Drive trains (motors and inverters)”