Question anyone any guidance how thick the copper needs tobe between 2 modules?
Anyone any idea how to protect the copper strip/bar? Will heat shrink do?
Is there need to use some kind of paste between the terminals and the copper?
Battery copper and some questions...
- EV_Builder
- Posts: 1199
- Joined: Tue Apr 28, 2020 3:50 pm
- Location: The Netherlands
- Has thanked: 16 times
- Been thanked: 33 times
- Contact:
Battery copper and some questions...
Converting an Porsche Panamera
see http://www.wdrautomatisering.nl for bespoke BMS modules.
see http://www.wdrautomatisering.nl for bespoke BMS modules.
- Romale
- Posts: 448
- Joined: Fri May 20, 2022 4:16 pm
- Location: Romania
- Has thanked: 208 times
- Been thanked: 45 times
Re: Battery copper and some questions...
EV_Builder wrote: ↑Thu Mar 17, 2022 2:23 pm Question anyone any guidance how thick the copper needs tobe between 2 modules?
it depends on which terminals are on your battery cells. For example, I use new Catl with laser-welded screws. there are aluminum terminals and using copper tires is very stupid. So I go to Leroy Merlin and buy an inexpensive 20x2 mm aluminum strip . this is enough with a margin and does not require any protection.
evil neodymium