Manual Mode is not working

Post Reply
EvPrud
Posts: 8
Joined: Sat Jan 07, 2023 11:13 am

Manual Mode is not working

Post by EvPrud »

I have Board Rev.3 and Prius Gen2. Supply 12 V on all devices, but an oscilloscope does not show frequency on PWM1_any outputs in Manual Mode. Writes 'Invertor started', with no errors. Boost is 37813, ampnom 70 %. IN_MPROT, IN_START, IN_FWD are connected to 12 V. The red LED on the plate is blinking.
EvPrud
Posts: 8
Joined: Sat Jan 07, 2023 11:13 am

Re: Manual Mode is not working

Post by EvPrud »

Additionally, I got [15]: STOP - OVERCURRENT .
User avatar
johu
Site Admin
Posts: 5684
Joined: Thu Nov 08, 2018 10:52 pm
Location: Kassel/Germany
Has thanked: 154 times
Been thanked: 960 times
Contact:

Re: Manual Mode is not working

Post by johu »

EvPrud wrote: Sun Feb 05, 2023 11:18 am Additionally, I got [15]: STOP - OVERCURRENT .
It means it drops straight out of manual mode again. Either connect current sensors (recommended) or supply around 2.5V to the current sensor inputs
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
EvPrud
Posts: 8
Joined: Sat Jan 07, 2023 11:13 am

Re: Manual Mode is not working

Post by EvPrud »

Il_1 and Il_2 have 2.23 V potential.
EvPrud
Posts: 8
Joined: Sat Jan 07, 2023 11:13 am

Re: Manual Mode is not working

Post by EvPrud »

How can I define that the inverter is working itself or not ? I see 0V on 7 and 12 its terminals instead of 2.5V .
User avatar
johu
Site Admin
Posts: 5684
Joined: Thu Nov 08, 2018 10:52 pm
Location: Kassel/Germany
Has thanked: 154 times
Been thanked: 960 times
Contact:

Re: Manual Mode is not working

Post by johu »

Please post a picture of your exact setup. Are you using the square mainboard instead of the Prius board with Gen2 inverter?
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
EvPrud
Posts: 8
Joined: Sat Jan 07, 2023 11:13 am

Re: Manual Mode is not working

Post by EvPrud »

Yes, I 'm using the square board Rev3.
Attachments
setup.jpg
EvPrud
Posts: 8
Joined: Sat Jan 07, 2023 11:13 am

Re: Manual Mode is not working

Post by EvPrud »

As I understood UN2003A must be added.
Post Reply