Tesla LDU Schematics

Topics concerning the Tesla front and rear drive unit drop-in board
Post Reply
wjones
Posts: 3
Joined: Fri Jul 26, 2019 10:37 pm

Tesla LDU Schematics

Post by wjones »

HI All
Just looking at the LDU schematics, and note the pinouts for the JST Dual Row connectors do not match the board layout.
The numbering in the Schematic appears to be board pad positions from right to left, where the JST Connector is right to left for top row then right to left for bottom row, and doesn't help that pin 1 is physically the second pin at the pad
LDU Connector Schematic.PNG
SM24B-CPTK-1A-TB.PNG
This would make the board pad numbering for the IGBT Driver connector 13,1,14,2...

Also to note,
Current sensor A is measuring Phase C.
If the naming convention for the phases was changed from ABC to CBA then Current sensor A would measure Phase A
(Sensor B currently, measures Phase B)
IMG_4580_A.jpg
It appears all versions of LDU Schematics have this, and is common for all dual row connectors.
Cheers
W
User avatar
johu
Site Admin
Posts: 5684
Joined: Thu Nov 08, 2018 10:52 pm
Location: Kassel/Germany
Has thanked: 154 times
Been thanked: 960 times
Contact:

Re: Tesla LDU Schematics

Post by johu »

Thanks for the info, never checked that.
The software doesn't do current control so fortunately the current sensor phases don't matter.
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
User avatar
catphish
Posts: 954
Joined: Fri Oct 08, 2021 11:02 pm
Location: Dorset, UK
Has thanked: 93 times
Been thanked: 179 times

Re: Tesla LDU Schematics

Post by catphish »

johu wrote: Mon Jan 09, 2023 10:40 am Thanks for the info, never checked that.
The software doesn't do current control so fortunately the current sensor phases don't matter.
This might matter soon :(
I'm currently writing code that requires multiplying current and voltage per-phase, which means they need to be matched up. It shouldn't be hard to make these remappable though, I'll keep it in mind.
User avatar
johu
Site Admin
Posts: 5684
Joined: Thu Nov 08, 2018 10:52 pm
Location: Kassel/Germany
Has thanked: 154 times
Been thanked: 960 times
Contact:

Re: Tesla LDU Schematics

Post by johu »

Could port pinswap over to sine software then
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
Post Reply